The immobilized lipase was prepared as previously described [12]. For enzyme immobilization, 1 ml of lipase solution (1.0 mg ml−1 of lipase in 50 mM, pH 8.0 Tris–HCl buffer) was mixed with 18 mg of NPG. Then, the mixture was incubated at 4°C without shaking for a certain period of time. After incubation, the supernatant was removed by centrifugation (5,000×g for 5 min), and the resulting lipase-NPG biocomposite was washed five times with Tris–HCl buffer (50 mM, pH 8.0) to remove the weakly adsorbed enzyme. The amount

of immobilized enzyme was determined by Bradford protein assays [17]. For selleck chemicals llc leaching PF477736 price test, the lipase-NPG biocomposite was incubated in Tris–HCl buffer (50 mM, pH 8.0) for 0.5 and 5 h at 40°C, respectively. Then, the Tris–HCl buffer was removed. The catalytic activity of the lipase-NPG biocomposite

was determined. The catalytic activities of free lipase and the lipase-NPG biocomposite were determined by measuring the initial hydrolysis rate of 4-nitrophenyl palmitate (pNPP) by lipase at 40°C, using a spectrophotometer (2100), following the increase of p-nitrophenol (pNP) concentration at 410 nm [12]. One unit (U) of catalytic activity is defined as the amount of lipase Transmembrane Transporters inhibitor which catalyzes the production of 1 μg p-nitrophenol under the experimental conditions. For reusability test, the lipase-NPG biocomposite was washed with Tris–HCl buffer (50 mM, pH 8.0) for three times after catalytic activity determination in each cycle, and then used in the next cycle. Results and discussion Characterization of lipase-NPG biocomposites Samples of NPG (pore size of 35 nm) before and after lipase loading were characterized using SEM. Figure 1A illustrates an open three-dimensional nanoporous structure. EDS compositional

analysis reveals that only Au was observed, indicating that the residual Ag is below the detection limit of about 0.5% (Figure 1C). After lipase loading, the pores of NPG were filled and the edge of ligaments became dim (Figure 1B) compared with bare NPG (Figure 1A). In addition, EDS analysis confirmed the existence of dominant elements such as C, N, and O (Figure 1D), providing a primary evidence of successful lipase immobilization Ponatinib mouse on NPG. Figure 1 SEM images of NPG with a pore size of 35 nm. (A) Before and (B) after lipase loading, and (C, D) its corresponding EDS spectra, respectively. Catalytic activity of lipase-NPG biocomposites For the immobilization of lipase, the suitability of NPG with pore sizes of 35 and 100 nm was investigated, respectively. As shown in Figure 2A, similar adsorption profiles were obtained for NPG with pore sizes of 35 and 100 nm. The loadings of lipase on NPG with pore sizes of 35 and 100 nm all reached stationary phase at 60 to 84 h simultaneously. At equilibrium state, the lipase loadings were all higher than 90% of the initial protein amount.