The glass slides containing the adhered bacteria and eukaryotic cells were fixed and hybridized with both PNA probes and observed in fluorescence microscopy,
as referred above. An additional 4′,6-diamidino-2-phenylindole (DAPI; Sigma, Portugal) staining step was done at the end of the hybridization procedure, covering each of the glass slides with 10 μl of DAPI for 5 min at room temperature in the dark, followed by immediate observation in the fluorescence microscope. All these assays were repeated three times, on separate days, with three fields of view assessed each time. Table 4 Efficiency of the Lactobacillus spp. and G. vaginalis detection in adhesion assays with HeLa cell line Concentration of cells (CFU/ml) Multiplex PNA-FISH assay L. crispatus G. vaginalis 5-1 Lac663 #www.selleckchem.com/products/c646.html randurls[1|1|,|CHEM1|]# Probe efficiency Gard162 Probe efficiency 1×109 1×109 +++ +++ 1×105 1×105 +++ +++ 1×103 1×103 ++++ +++ L. iners G. vaginalis 5-1 Lac663 Probe efficiency Gard162 Probe efficiency 1×109 1×109 +++ +++ 1×105 1×105 +++ +++ 1×103 1×103 ++ +++ The PNA probe (Lac663 and Gar162) efficiencies were tested in each sample with the following hybridization PNA FISH qualitative evaluation: (++) Moderate hybridization; (+++) Good hybridization; (++++) Optimal hybridization.
The table shows the median value from the three experiments for each sample. Results In silico analysis of PNA probes The Lac663 probe showed a theoretical sensitivity and specificity of 91.5% and 99.7%, respectively, which corroborates the previously reported values [26]. Actually, this publication shows that these probes match the best values of URMC-099 order the existing Lactobacillus probes. Gard162 probe presented a theoretical sensitivity of 95.0% and specificity of 100%. The theoretical specificity and sensitivity of these two probes and those developed in other studies were calculated as previously described by Almeida et al.[27] and are listed in Table 2. ProbeMatch tool, from RPDII (http://rdp.cme.msu.edu/probematch/; last accession, May 2012), was used with the following data set options: Strain – Both; Source – Both; Size
– > 1200 bp; Quality – Both. For Lactobacillus probes, the specificity and sensitivity values previously Thymidine kinase determined [26], were considered. FISH Protocol optimization and autofluorescence-related factors FISH protocols on slides and in suspension were adapted from previous protocols developed by Almeida et al. [37], due to the crucial importance of fixation and hybridization conditions for an efficient multiplex FISH with different probes. From an initial temperature range of 50 to 72°C and an incubation time range between 30 and 180 min, the best hybridization conditions were set as a moist chamber temperature of 60°C during 90 min of incubation (data not shown). Hybridization conditions started to reveal strong signal-to-noise ratio at 59°C to 61°C from 30 min of incubation up to 120 min, reaching its peak at 60°C during 90 min of incubation.